User Manual
Table Of Contents
- Package Contents
- Hardware Description
- Installing the Switch
- Installation Steps
- DIN-Rail Mounting
- Wall Mount Plate Mounting
- Wiring the Power Inputs
- Wiring the Fault Alarm Contact
- Wiring the Digital Inputs / Outputs (GE-DSH-73)
- Installing the SFP transceiver
- Factory Redundant Ring Application
- Transportation Networking and Public Wireless Service
- X-Ring Application
- Coupling Ring Application
- Dual Homing Application
- Connecting to the Console Port
- Login in the Console Interface
- CLI Management
- About Web-based Management
- Requirements
- Logging on the Switch
- System
- Port Management
- Protocol
- Security
- Digital Input/Output (GE-DSH-73)
- Power Over Ethernet (GE-DSH-82-PoE)
- Factory Default
- Save Configuration
- System Reboot
- System Commands Set
- Port Commands Set
- Trunk Commands Set
- VLAN Commands Set
- Spanning Tree Commands Set
- QOS Commands Set
- IGMP Commands Set
- MAC / Filter Table Commands Set
- SNMP Commands Set
- Port Mirroring Commands Set
- 802.1x Commands Set
- TFTP Commands Set
- SystemLog, SMTP and Event Commands Set
- SNTP Commands Set
- X-ring Commands Set
- PoE Command Set
- Address Table
- What is PoE?
- Switch's RJ-45 Pin Assignments
- 10/100Mbps, 10/100Base-TX
Chapter 5: Web-Based Management
84 GE-DSH-73/DSH-82 and DSH-82-PoE User Manual
• Hybrid: The port belongs to VLANs, and each VLAN is user-defined as tagged or
untagged (full 802.1Q mode). Ports will strip the 802.1Q tag from all packets that
out of those ports.
Port Mode VLAN Membership Frame Leave
Access Link Belongs to a single untagged VLAN
Untagged
( Tag=PVID be removed)
Trunk Link
Allowed to belongs to multiple Tagged
VLANs at the same time
Tagged
(Tag=PVID or Original VID be remained)
Hybrid Link
Allowed to belongs to multiple untagged
VLANs at the same time
Untagged by specify VID
The 802.1Q VLAN Port Configuration screen is shown below:
Figure 5-34: 802.1Q VLAN mode