User Manual
Table Of Contents
- Package Contents
- Hardware Description
- Installing the Switch
- Installation Steps
- DIN-Rail Mounting
- Wall Mount Plate Mounting
- Wiring the Power Inputs
- Wiring the Fault Alarm Contact
- Wiring the Digital Inputs / Outputs (GE-DSH-73)
- Installing the SFP transceiver
- Factory Redundant Ring Application
- Transportation Networking and Public Wireless Service
- X-Ring Application
- Coupling Ring Application
- Dual Homing Application
- Connecting to the Console Port
- Login in the Console Interface
- CLI Management
- About Web-based Management
- Requirements
- Logging on the Switch
- System
- Port Management
- Protocol
- Security
- Digital Input/Output (GE-DSH-73)
- Power Over Ethernet (GE-DSH-82-PoE)
- Factory Default
- Save Configuration
- System Reboot
- System Commands Set
- Port Commands Set
- Trunk Commands Set
- VLAN Commands Set
- Spanning Tree Commands Set
- QOS Commands Set
- IGMP Commands Set
- MAC / Filter Table Commands Set
- SNMP Commands Set
- Port Mirroring Commands Set
- 802.1x Commands Set
- TFTP Commands Set
- SystemLog, SMTP and Event Commands Set
- SNTP Commands Set
- X-ring Commands Set
- PoE Command Set
- Address Table
- What is PoE?
- Switch's RJ-45 Pin Assignments
- 10/100Mbps, 10/100Base-TX
Chapter 5: Web-Based Management
86 GE-DSH-73/DSH-82 and DSH-82-PoE User Manual
Object Description
Tagged VID:
This column field is available when Link Type is set as Trunk Link and
Hybrid Link. Assign a number in the range between 1 an 4094.
NOTE: Access Link:
Because the access port doesn't have an understanding of tagged frame, the column
field of Tagged VID is not available.
NOTE: Trunk Link
1. A trunk port doesn't insert tag into an untagged frame, and therefore the untagged
VID column field is not available.
2. It's not necessary to type '1' in the tagged VID. The trunk port will forward the
frames of VLAN 1.
3. The trunk port has to be connected to a trunk/hybrid port of the other switch. Both
the tagged VID of the two ports have to be the same.
NOTE: Hybrid Link
1. It's not necessary to type '1' in the tagged VID. The hybrid port will forward the
frames of VLAN 1.
2. The trunk port has to be connected to a trunk/hybrid port of the other switch. Both
the tagged VID of the two ports have to be the same.
• Pull down the selection item and focus on 802.1Q then press to set the VLAN
Operation Mode in 802.1Q mode
• You can see the link type, untagged VID, and tagged VID information of each port
in the table below on the screen.