Installation Guide

Table Of Contents

b. Adjust the pan direction [0°~360°].

c. Adjust the tilt direction [0°~90°].

d. Rotate the camera [0~360°] to adjust the lens to the

surveillance angle.

e. Tighten the adjustable nut (1) to complete the installation.

Waterproof jacket assembly

We recommended using the waterproof jacket to protect network

cabling when the camera is installed outdoors.

To assemble the waterproof jacket:

1. Remove the connector (3) from the end of the network cable

(7).

2. Route the network cable through the waterproof jacket

components in the following sequence: fixed nut (6),

waterproof ring (5), and the main body of the waterproof jacket

(4).

3. Insert the waterproof ring into the main body of the waterproof

jacket.

4. Reattach the plug to the end of the network cable.

5. Place the O-ring (2) in the network interface (1) of the camera,

and then connect the network cable.

6. Connect the network interface to the waterproof jacket, and

then rotate the fixed nut clockwise to connect it to the main

body of the waterproof jacket.

. Network interface

. O-ring

. Connector

4. Waterproof jacket

5. Waterproof ring

6. Fixed nut

7. Network cable