Installation Guide
Table Of Contents
- Product overview
- Installation environment
- Package contents
- Camera description – Bullet Camera
- Camera description – Desktop Camera
- Accessing the Micro SD card
- Mounting
- Browser requirements
- Quick setup
- Alternative methods of adding cameras
- UltraSync app basic functions
- Change default camera settings
- Reset cameras to factory default
- Troubleshooting
- Specifications
Quick setup
Note: If the light source where the camera is installed
experiences rapid, wide variations in lighting, the camera may not
operate as intended.
To quickly put the camera into operation:
1. Mount the camera. (See “Mounting” on page 10)
2. Connect the camera to a local network via Wi-Fi. (See “2. Add
cameras to a Wi-Fi network” on page 15)
3. Add the camera to the UltraSync app. (See “3. Add cameras
to UltraSync” on page 17)
4. Reboot cameras. (See “4. Reboot cameras” on page 18)
1. Setting up Ethernet/Wi-Fi transmission
Wi-Fi transmission distance
The Wi-Fi transmission distance/range of the camera is
approximately 50 m (164 ft.) in open air applications.
Note: The transmission distance may vary due to the presence of
physical obstacles such as trees, walls, elevators, fire doors,
furniture, etc. Avoid very solid walls and metallic objects in the
transmission path.
Other Wi-Fi networks (for example Wi-Fi, WiMAX) operating on
2.4 GHz and certain types of devices (such as microwave ovens
or point-to-point Wi-Fi transmissions) can cause interference with
the network and a reduction in transmission distance/range.
Wi-Fi signal strength
Wi-Fi signal strength can be checked in the Wireless List in the
camera’s browser interface (see “Add cameras to a Wi-Fi
network” on page 15). Use the scale below to determine if actions
are needed to improve performance.
Below 65
Poor
65-75
Good
75-85 Very
Good
85+
Excellent
14 P/N 466-5303-EN • REV A • ISS 25MAY17 © 2017 United Technologies Corporation. All rights reserved.