Installation Guide

Table Of Contents

Note: It may take up to two minutes for the camera to boot up.

The IR LED on the bullet camera and the LINK LED on the

desktop camera blink slowly to indicate that the temporary

Wi-Fi connection is enabled

2. Note the model and serial numbers on the camera.

3. Find the camera in the list of wireless networks available to the

device being used for setup and initiate connection.

4. Enter the camera’s serial number as the security

key/password.

5. Log in to the browser interface (see “Browser requirements”

on page 13) using the default settings:

 Camera's default IP address: 192.168.2.70

 User Name: admin

 Password: 1234

Note: A pop-up may appear asking for an immediate

password change. We strongly recommend changing the

password. Select OK in this dialog and any subsequent

dialogs that may appear.

6. Click or tap the Configuration tab.

Note: A pop-up may appear prompting for plug-in installation.

Follow the installation prompts to install the plug-in.

7. Select Network and then select Wi-Fi on the left menu.

8. Click or tap Search.

9. Click or tap on the Wi-Fi network to be used for the camera in

the Wireless List.

10. Type the Wi-Fi network passphrase in the Key 1 field.