Installation Guide

Table Of Contents

5. The “Success!” message appears after a few seconds.

Note: The “Success" message appears after a camera scan is

executed. This does not indicate that cameras were added to

the system.

6. The IP and MAC addresses automatically populate for all

cameras on the network. Scroll down to view and verify

connected cameras.

7. Tap Save.

Note: The camera may take up to two minutes to finalize

association with the intrusion panel and appear in the cameras

tab.

4. Reboot cameras

1. Launch the TruVision

IP camera configuration browser.

2. Select System and then select Maintenance on the left menu.

3. Select Reboot.

4. Select OK when asked to reboot the unit.

Note: Reboot may take up to two minutes.

5. Go to the Cameras tab in the UltraSync app to verify live

video.

Camera installation is now complete!

Alternative methods of adding cameras

Add cameras via Ethernet with a Windows PC

1. Apply power to the camera using the included power supply.

Note: It may take up to two minutes for the camera to boot up.

2. Connect the camera to a router with an Ethernet cable.

3. Launch TruVision Device Manager.

Note: Install TruVision Device Manager using the included CD

or download it from www.interlogix.com/video.

4. Verify that the camera is found in the main camera selection

window.

5. Select the camera to be configured.

6. In the Password field, type the default password (1234) and

click Save.

7. In the main camera selection window, select the camera to be

configured and double-click the IPV4 Address to launch

TruVision IP Camera Configurator in a browser.