Installation Guide

Table Of Contents

Change default camera settings

Default camera settings can be modified using the camera’s

browser configuration interface.

To determine the IP address of the camera to be configured:

 Launch the TruVision Device Manager and locate the camera

in the list by device type and/or serial number. The IP address

is listed next to device type.

 Launch the UltraSync app and tap the menu icon at the top left

of the screen, tap Settings, and then tap Cameras in the

Settings Selector drop-down list.

Note: UltraSync installer privileges are required to view

camera IP addresses.

To access the camera’s browser configuration interface:

 Type the IP address obtained using one of the methods above

into a browser (see “Browser requirements” on page 13), and

then enter the login credentials.

 In TruVision Device Manager, double-click the IPV4 Address

of the camera in the Device finder tab, and then enter the login

credentials.

TruVision Device Manager

In addition to finding device IP addresses, camera IP settings can

be changed in Device Manager without launching the browser

configuration interface.

TruVision Navigator

UltraSync cameras are compatible with TruVision Navigator video

management system software, which delivers powerful

centralized and remote video management capabilities.

Note: Go to www.interlogix.com/video to download TruVision

Device Manager and TruVision Navigator. See the TruVision

Device Manager User Manual and the TruVision Navigator User

Manual for further information and capabilities.