Installation Guide

Table Of Contents

Product overview

This is the installation guide for the following UltraSync IP camera

models:

 RS-3230/3231 (1080p IP Wi-Fi Desktop IR camera)

 RS-3250/3251 (1080p IP Wi-Fi Bullet IR camera)

Installation environment

When installing the product, consider these factors:

 Electrical: Electrical wiring should be installed carefully by

qualified service personnel. Always use a proper Power over

Ethernet (PoE) switch or a 12 VDC UL listed Class 2 or CE

certified power supply to power the camera. Do not overload

the power cord or adapter.

 Ventilation: Ensure that the location planned for the

installation of the camera is well ventilated.

 Temperature: Do not operate the camera beyond the

specified temperature, humidity, or power source ratings. The

operating temperature of the camera is between -20 to +60°C

(-4 to 140°F). Humidity is below 90%.

 Moisture: Do not expose the camera to rain or moisture, or try

to operate it in wet areas. Turn the power off immediately if the

camera is wet and ask a qualified service person for servicing.

Moisture can damage the camera and also create the danger

of electric shock.

 Servicing: Do not attempt to service this camera yourself. Any

attempt to dismantle or remove the covers from this product

invalidates the warranty and may also result in serious injury.

Refer all servicing to qualified service personnel.

 Cleaning: Do not touch the sensor modules with fingers. If

cleaning is necessary, use a clean cloth with some ethanol

and wipe the camera gently. If the camera will not be used for

an extended period of time, put on the lens cap to protect the

sensors from dirt.

 Reflectivity: Ensure that there is no reflective surface too

close to the camera lens. The IR light from the camera may

reflect back into the lens causing reflection.