Configuration Manual Instruction Manual

Chapter 2: Programming
TruVision Analog PTZ Camera Configuration Manual 11
4. Click the up/down buttons to increase/decrease the value.
5. Click IRIS+ button to confirm and exit.
Zero point (initial position) setting
You can define the initial position of the PTZ camera using the Zero Point Setting
submenu.
To change the zero point setting:
1. Go to Main Menu > System Settings > System Infor Settings.
2. Use the direction buttons to move the cursor to Zero Point Setting and click
IRIS+ to enter.
3. Click the left/right/up/down buttons to adjust the monitor angle of the PTZ camera
to find the initial position.
4. Click IRIS+ button to confirm and exit.
Display settings
You can enable or disable the on-screen display for the information of zoom, PTZ
movements, alarms, time, presets, zone, address, error rate, and fan and heat, etc. See
Figure 3 below.
Figure 3: Display settings menu