Configuration Manual Instruction Manual

Chapter 2: Programming
TruVision Analog PTZ Camera Configuration Manual 23
To clear a preset setting:
1. Go to MAIN MENU > SYSTEM SETTINGS > PRESETS
2. Move the cursor to CLEAR PRESET and click IRIS+ to clear the settings of the current
preset.
Preset tours
A preset tour is a sequence of presets stored in the system memory and recalled when
required, either upon an alarm trigger, when programmed, or on manual recall. See
Figure 8 below.
Up to 32 presets can be configured in sequence for a preset tour.
Figure 8: Preset tour menu
To set a preset tour:
1. Go to MAIN MENU > SYSTEM SETTINGS > PRESET TOUR
2. Move the cursor to TOUR NUMBER and click IRIS+ to enter edit mode.
3. Click the up and down buttons to select the number of the preset tour to be configured.
4. Click IRIS+ again to confirm and exit edit mode of this column.
Note: You can configure up to 8 Preset Tours.