Configuration Manual Instruction Manual

Chapter 2: Programming
30 TruVision Analog PTZ Camera Configuration Manual
To set a zone status and scan status:
1. Go to MAIN MENU > SYSTEM SETTINGS > ZONES.
2. Move the cursor to the function and click IRIS+ to enter. Select the function:
ZONE STATUS: Enable/disable the current status of the zone.
SCAN STATUS: Enable/disable the scanning in the zone.
Note: ZONE STATUS cannot be changed. When you have edited a zone, it switches to
ON automatically. If the zone is deleted, the ZONE STATUS switches to OFF.
To clear the zone settings:
1. Go to MAIN MENU > SYSTEM SETTINGS > ZONES.
2. Move the cursor to CLEAR ZONE and click IRIS+ to clear all the settings of the current
zone.
Clear PTZ control settings
You can clear all user-defined PTZ control settings, including presets, preset tours, shadow
tours, zones, and time tasks. You can also clear privacy masks from this menu. See
Figure 12 below.
Figure 12: Clear PTZ settings menu
To clear PTZ settings:
1. Go to MAIN MENU > SYSTEM SETTINGS > CLEAR SETTINGS.
2. Click IRIS+ on each submenu to be deleted. For example, CLEAR SHADOW TOURS.
3. Click IRIS+ again to confirm and exit.