Configuration Manual Instruction Manual

TruVision Analog PTZ Camera Configuration Manual 5
Chapter 1
Introduction
Before programming, ensure that the PTZ camera has the power, control, video
cables correctly connected. For information on installing the PTZ camera, please
refer to the “Truvision Analog PTZ camera Installation Manual” supplied with the
PTZ camera.
The PTZ camera is programmed through the on-screen (OSD) menus. You can
access to the OSD menu of a PTZ camera by using a control device, such as a
keypad, DVRs, etc. For the control cable connection and communication settings
with a control device, please see the correspondent user manual of the control
device.
Power-up action
When the unit is powered up, the PTZ camera will perform a series of self-test
actions. Meanwhile, a splash screen appears that displays important system
information for two minutes, as shown below.
The system information may change depending on user’s settings or models.