Configuration Manual Owner manual

ManualsBrandsInterlogix ManualsVideo surveillance systemsTruVision Intelligent IP Dome

34 TruVision 12/32 Series IP Camera Configuration Manual

3. Specify the linkage method when an event occurs. Check one or more response

methods for the system when a tamper-proof alarm is triggered.

Notify Alarm Recipient

Send an exception or alarm signal to remote management

software when an event occurs.

Send Email

Sends an email to a specified address when there is an

exception alarm.

Note: You must configure email settings before enabling this

option. See “To set up the email parameters” on page 16 for

further information. If you want to send the event snapshot

together with the email, check the Attached Snapshot option.

Upload Snapshot

Capture the image when an alarm is triggered and upload the

picture to NAS or FTP server.

Note

: To upload the snapshot to NAS, you must first configure

the NAS settings. See “NAS settings” on page 48 for further

information.

T To upload the snapshot to an FTP, you must first configure

the FTP settings. See “To define the FTP parameters” on page

15 for further information. Enable the Upload Type option.

To upload the snapshot to FTP and NAS when motion

detection or an alarm input is triggered, you must also enable

Enable Event-triggered Snapshot under the snapshot

parameters. See “Snapshot parameters” on page 46

for further

information.

Trigger Channel

Triggers the recording to start in the camera.

Trigger Alarm Output

Trigger external alarm outputs when an event occurs. Check

“Select All” or each individual alarm output.

Note: This option is only supported by cameras that support

alarm output.

4. Click Save to save changes.

Alarm inputs and outputs

To define the external alarm input:

1. From the menu toolbar, click Configuration > Events > Alarm Input.

2. Choose the Alarm Input No. and the Alarm Type. The alarm type can be NO

(Normally Open) and NC (Normally Closed). Enter a name for the alarm input.

3. Click Edit to set the arming schedule for the alarm input. See “To set up motion

detection” for more information.

4. Check the checkbox to select the linkage method.