Configuration Manual User guide

1BChapter 2: Camera operation
24 TruVision IP Camera Configuration Manual
4. Click Stop Drawing to finish drawing. Click Clear All to delete all areas
marked and restart drawing.
5. Move the Sensitivity slider to set the sensitivity of the detection.
All areas will have the same sensitivity level.
6. Click Edit to edit the arming schedule. See the picture below for the editing
interface of the arming schedule.
7. Choose the day and click to set the detailed time period. You can copy
the schedule to other days.
8. Click OK to save changes.
9. Specify the linkage method when an event occurs. Check one or more
response methods for the system when a motion detection alarm is triggered.
Notify Surveillance Cente
r Send an exception or alarm signal to remote
management software when an event occurs.
Send
Email Sends an email to a specified address when there is a
motion detection alarm.
Upload Snapshot
Capture the image when an alarm is triggered and
upload the picture to NAS or FTP server.
Trigger
Channel Triggers the recording to start in the camera.
Trigger
Alarm Output Trigger external alarm outputs when an event occurs.
Note: This option is only supported by cameras that
support alarm output.
10. Click Save to save changes.
Tamper-proof alarms
You can configure the camera to trigger an alarm when the lens is covered and
to take an alarm response action.