User Manual Owner manual

1BChapter 2: Installation
6 TruVision Outdoor IP Camera User Manual
Setting up the camera
Note: If the light source where the camera is installed experiences rapid, wide-
variations in lighting, the camera may not operate as intended.
To quickly put the dome camera into operation:
1. Prepare the mounting surface.
2. Connect the power and network cables to the camera. See “Connecting the
devices” on page 6.
3. Mount the camera to the ceiling using the appropriate fasteners. See
“Mounting the dome cameras on a ceiling” on page 8.
4. Set up the camera’s network and streaming parameters so that the camera
can be controlled over the network. See “Chapter 3 Network and streaming
configuration” on page 15.
5. Program the camera to suit its location. See “Chapter 4 Camera
configuration” on page 25.
To quickly put the bullet camera into operation:
1. Prepare the mounting surface.
2. Connect the power and network cables to the camera. See “Connecting the
devices” on page 6.
3. Mount the camera to the ceiling using the appropriate fasteners. See
Mounting the bullet camera” on page 8.
4. Set up the camera’s network and streaming parameters so that the camera
can be controlled over the network. See “Chapter 3 Network and streaming
configuration” on page 15.
5. Program the camera to suit its location. See “Chapter 4 Camera
configuration” on page 25.
Connecting the devices
A qualified service person, complying with all applicable codes, should perform
all required hardware installation.