User Manual Owner manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Installation
- Installation environment
- Package contents
- Cable requirements
- Camera descriptions
- Setting up the camera
- Connecting the devices
- Accessing the SDHC card
- Mounting the dome cameras on a ceiling
- Mounting the bullet camera
- Using the camera with TVR 60/ TVN 20/ TVN 40/ LNVR and other systems
- Using the camera with TruVision Navigator
- Chapter 3 Network and streaming configuration
- Chapter 4 Camera configuration
- Chapter 5 Camera management
- Chapter 6 Camera operation
- Appendix A Specifications
- Appendix B Pin definitions
- Index
3BChapter 4: Configuring the camera
28 TruVision Outdoor IP Camera User Manual
Alarm parameters
For future use.
Events scheduling
Use the deployment time menu to schedule when events can be registered.
Outside of these scheduled periods, the system cannot register any events. You
can configure up to four event periods a day.
For the event schedule to be operational, you must also define the motion
detection parameters (see page 31) as well as the alarm input and output
parameters (see page 28.) The recording schedule for motion detection must fall
within the time period of the event schedule.
Figure 10: Deployment time menu
To define an event schedule:
1. Click the “Deployment” folder to open its window.
2. Under “Event type” select the Motion detection.
3. Select the day of the week and the time period for the event schedule. The
time periods must not overlap.
4. Select another day of the week to set up its event schedule.
- Or -
Copy the event schedule to other days of the week by checking the days
required and click Copy.
5. Click Save to save changes.