User Manual Manual
Table Of Contents
- Chapter 1 Product overview
- Chapter 2 Installation
- Chapter 3 Getting started
- Chapter 4 Operating instructions
- Chapter 5 Recording settings
- Chapter 6 Alarm settings
- Chapter 7 Network settings
- Chapter 8 Storage management
- Chapter 9 Camera settings
- Chapter 10 Live view
- Chapter 11 Controlling a PTZ camera
- Chapter 12 Playing back a recording
- Overview of the playback window
- Playback pop-up menu
- Instant playback
- 24-hour playback
- Playback speed and skip time
- Searching recorded video
- Playing back recordings by time and video type
- Playing back recordings by event
- Creating and playing back bookmarked recordings
- Slideshow of snapshots
- Playing back recordings from the system log
- Playing back frame-by-frame
- Digital zoom in playback
- Chapter 13 Archiving recorded files
- Chapter 14 NVR management
- Chapter 15 User management
- Chapter 16 Using the web browser
- Appendix A Specifications
- Appendix B Port forwarding information
- Appendix C Maximum pre-recorded times
- Appendix D Default menu settings
- Appendix E Product codes
- Index
Chapter 7: Network settings
50 TruVision NVR 10 User Manual
FTP server setup to store snapshots
You can upload your snapshots to an FTP server for storage.
Note: It is not possible to stream video to an FTP site.
To configure the FTP server settings:
1. From the menu toolbar, click Network Settings > FTP.
2. Check the Enable FTP box.
3. Enter the FTP server information: Server address, FTP port, user name, and
password.
4. Select the desire directory. The root directory is default.
5. Click Apply to save the settings.
6. Click Back to return to live view, or continue configuring the NVR settings.
SNMP setup
SNMP is a protocol for managing devices on networks. When you enable SNMP in the
menu, network management systems can retrieve NVR status information from the
NVR via SNMP.
When you set the trap address and trap port in the NVR menu to the network
management system’s IP address and port number, and set up the network
management system as trap receiver, trap notifications (such as startup) are sent from
the NVR to the network management system.
Before configuring this function, you must first install the SNMP software.
To configure SNMP protocol settings:
1. From the menu toolbar, click Network Settings > SNMP.
2. Check the Enable SNMP box.
3. Enter the required SNMP settings: SNMP version (V2 is default), SNMP port read
community, write community, trap address, and trap port.
4. Click Apply to save the settings.
5. Click Back to return to live view, or continue configuring the NVR settings.
UPnP setup
The NVR supports UPnP
TM
(Universal Plug and Play). This feature lets the NVR
automatically configure its own port forwarding, if this feature is also enabled in the
router.
You can select one of two methods to set up UPnP: