Owner manual

ManualsBrandsInterlogix ManualsVideo surveillance systemsTVC-5125BE-3

P/N 1072502A • ISS 04JUN12

TVC-5125BE-3 Bullet IR

Camera Pocket Guide

Overview

This is the Pocket Guide for TVC-5125BE-3-P/TVC-

5125BE-3-N Bullet IR Camera. The guide describes a

standard installation.

The camera consists of the following:

• Camera with power and video output cable

• Mounting bracket

• Sunshield

Refer to the figures when performing the camera

setup procedures.

Summary of content (8 pages)

PAGE 1
TVC-5125BE-3 Bullet IR Camera Pocket Guide Overview This is the Pocket Guide for TVC-5125BE-3-P/TVC5125BE-3-N Bullet IR Camera. The guide describes a standard installation. The camera consists of the following: • Camera with power and video output cable • Mounting bracket • Sunshield Refer to the figures when performing the camera setup procedures.
PAGE 2
Figure 1. Parts of the camera 2 A. Sunshield B. Video and power cables C.
PAGE 3
Figure 2: Camera front A. 18 LED IR lights B. Lens C.
PAGE 4
Figure 3: Mounting sticker template (mm) 4
PAGE 5
Figure 4: Dimensions Installation To install the camera: 1. Using the mounting sticker as a template, place it level against the mounting surface and mark the position of the mounting holes. 2. Following all local codes, drill and prepare the mounting holes.
PAGE 6
3. Securely fasten the mount to the mounting surface with the appropriate fasteners. 4. If needed, seal all mounting holes so that no moisture can leak into the mounting surface. 5. Screw the camera into the mounting bracket. Ensure that the camera is firmly attached to the bracket. 6. Connect a 75 ohm coaxial video cable to the video cable, and connect a 12 VDC power supply to the power cable. 7. Adjust the camera position and angle as required.
PAGE 7
Dimensions (H × W × L) 55 × 50 × 65 mm (2.2 × 4.9 × 4.95 in.) Contact information For contact information, see www.interlogix.com or www.utcfssecurityproducts.eu. Regulatory information © 2012 UTC Fire & Security. All rights reserved. Manufacturer UTC Fire & Security Americas Corporation, Inc. 2955 Red Hill Avenue, Costa Mesa, CA 92626 5923, USA Authorized EU manufacturing representative: UTC Fire & Security B.V.
PAGE 8
ACMA compliance Notice! This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. Canada This Class A digital apparatus complies with Canadian ICES003. Cet appareil numérique de la classe A est conforme à la norme NMB-0330 du Canada.