TVD-5125TE-3 IR Dome Camera Pocket Guide 1: Cables A. Video cable; B. Power cable P/N 1072504A • REV A.
: Front of the camera A. LED IR lights; B. Lens; C.
Overview This is the pocket guide for the TVD-5125TE-3-P / TVD-5125TE-3-N IR Dome Camera. The guide describes a standard installation. The camera consists of the following: Camera with power and video output cables Hex wrench Refer to the figures in the front of the guide when performing the camera setup procedures. Installation To install the camera: 1. Using the mount as a template, place it level against the mounting surface and mark the position of the mounting holes. 2.
5. Screw the camera into the mounting bracket. Ensure that the camera is firmly attached to the bracket. 6. Connect a 75 ohm coaxial video cable to the video cable, and connect a 12 VDC power supply to the power cable. 7. Adjust the camera position and angle as required. Specifications Power supply 12 VDC Current 60 mA (IR Off) 180 mA (IR On) Power consumption 2 W max. Weight 0.7 lb. (320 g) Dimensions (H × Ø) 2.75 x 3.7 in. (70 x 94 mm) Contact information For contact information, see www.
Regulatory information © 2012 UTC Fire & Security. All rights reserved. Manufacturer UTC Fire & Security Americas Corporation, Inc. 2955 Red Hill Avenue, Costa Mesa, CA 92626 5923, USA Authorized EU manufacturing representative: UTC Fire & Security B.V. Kelvinstraat 7, 6003 DH Weert, The Netherlands FCC compliance Class B: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Certification N4131 European Union directives 12004/108/EC (EMC directive): Hereby, UTC Fire & Security declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2004/108/EC. 2002/96/EC (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted municipal waste in the European Union.
