User Manual Instruction Manual
Table Of Contents
- Product overview
- Installation
- Programming
- OSD control button
- Access the Setup menu
- Save changes
- Select the lens type
- Set shutter/AGC
- Set white balance
- Set backlight compensation (BLC)
- Adjust the picture characteristics
- Set ATR level
- Set motion detection
- Set privacy area
- Set Day/Night mode
- Set image noise reduction
- Set the camera ID
- Set sync mode
- Select the language
- Reset camera settings
- Specifications
- Menu Map
TruVision TVD-6120VE-2 / TVD-6125VE-2 Camera User Manual 5
Connect the cables
To make the cable connections:
1. Connect a 12 VDC or 24 VAC power supply to the power input.
2. Connect a coaxial cable from the camera’s BNC connector to a CCTV
monitor or video recording device.
Adjust the lens
The camera is mounted on a pan-tilt-twist (3-axis grimbal) rotating platform so
that it is easy to adjust the camera orientation.
To adjust the lens:
1. Rotate the panning table to adjust the panning position of the camera. The
adjusting range is from 0 to 355 degrees.
2. Rotate the tilting table to adjust the tilting position of the camera. The
adjusting range is from 0 to 75 degrees. Tighten the tilting table lock screw.
3. Rotate the lens to adjust the azimuth angle of the image. The adjusting range
is from 0 to 355 degrees.
Rotation 0-355°
Tilt 0-75°
Pan 0-355°
4. Adjust the lens to obtain the appropriate angle of view and the optimum focus.
Tighten the focus lock lever.
5. Replace the IR LED and dome covers on the camera.
6. Secure the dome cover with screws.