User Manual

32 TVE-110/410/810/1610 H.264 IP Video Encoder User Manual
4. Select the Stream Type of the camera to Main Stream (Normal), Main
Stream (Event) or Sub Stream.
The main stream is usually for recording and live viewing with good
bandwidth, and the substream can be used for live viewing when the
bandwidth is low. Refer to “Local configuration” on page 15 on changing the
main stream to sub stream for live viewing.
5. You can customize the following parameters for the selected Main Stream or
Sub Stream:
Video Type: Select the video type to video stream, or video & audio
composite stream. The audio signal will be recorded only when the Video
Type is Video & Audio.
Resolution: Select the resolution of the video input.
Bitrate Type: Select the bitrate type to constant or variable.
Video Quality: When bitrate type is selected to Variable, six levels of video
quality can be configured.
Frame Rate: Set the frame rate between 1/16 and 30 fps.
The frame rate used to describe the frequency at which a video stream is
updated is measured in frames per second (fps). A higher frame rate is
advantageous when there is movement in the video stream, as it maintains
image quality throughout.
Max. Bitrate: Set the Max. bitrate between 32 and 8192 Kbps.
I Frame Interval: Set the I frame interval between 1 and 400 (frames). The
higher value results in lower video quality.
Video Encoding: Select the video encoding standard to H.264, MPEG4 or
MJPEG.
6. If you want to copy the display settings of the current camera to other
cameras, go to the Copy to Camera panel and select the camera(s) to copy,
or click Select All to select all cameras.
7. Click Save to save the settings.
To configure Snapshot:
1. Click Configuration > Configuration > Camera Settings > Snapshot. The
Snapshot Setting window appears.