Installation Manual

Installation Manual 5
• Servicing: Do not attempt to service this camera yourself. Any attempt to
dismantle or remove the covers from this product will invalidate the warranty and
may also result in serious injury. Refer all servicing to qualified service personnel.
• Cleaning: Do not touch the sensor modules with fingers. If cleaning is necessary,
use a clean cloth with some ethanol and wipe the camera gently. If the camera will
not be used for an extended period of time, put on the lens cap to protect the
sensors from dirt.
Package contents
Check the package and contents for visible damage. If any components are damaged
or missing, do not attempt to use the unit; contact the supplier immediately. If the unit
is returned, it must be shipped back in its original packaging.
Package contents:
• Camera or lens
• Mounting accessories
• Installation manual
• CD with Configuration Manual and TruVision Device Manager
Note:
The ATM/covert camera has no lens in the product package. The lens needs to be
purchased separately according to the application needs. Please notice that there are
different cable length and form factor options.
CAUTION: Use direct plug-in UL listed power supplies marked Class 2/CE certified or
LPS (limited power source) of the required output rating as listed on the unit.
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to the instructions.
Cable requirements
For proper operation, adhere to the following cable and power requirements for the
cameras. Category 5 cabling or better is recommended. All network cabling must be
installed according to applicable codes and regulations.
Recommended power cable requirements to connect the camera:
12 VDC power jack or PoE (802.3-af)