User Manual
Table Of Contents
- Chapter 1 Product overview
- Chapter 2 Installation
- Chapter 3 Getting started
- Chapter 4 Operating instructions
- Chapter 5 Live view
- Chapter 6 Controlling a PTZ camera
- Chapter 7 Playing back a recording
- Overview of the playback window
- Playback pop-up menu
- Instant playback
- All-day playback
- Playback skip time
- Searching recorded video
- Playing back recordings by time and video type
- Playing back recordings by event
- Creating and playing back bookmarked recordings
- Slideshow of snapshots
- Playing back recordings from the system log
- Playing back frame-by-frame
- Digital zoom in playback
- Chapter 8 Archiving recorded files
- Chapter 9 Using the web browser
- Windows 7 and 8 users
- Accessing the web browser
- Web browser overview
- Using the web browser to configure the device
- Searching and playing back recorded video
- Searching for event logs
- Recording from the browser
- Dual stream recording
- Controlling a PTZ dome camera in the web browser
- Capturing text insertions
- Text overlay
- Using a network storage system
- Chapter 10 Recording
- Chapter 11 Alarm settings
- Chapter 12 Network settings
- Configuring general network settings
- Configuring an NTP server
- Configuring e-mail
- Configuring SNMP
- Configuring UPnP
- Configuring an FTP server to store snapshots
- Configuring a remote alarm host
- Configuring multicast
- Configuring the server and HTTP ports
- Configuring the RTSP service port
- Telnet set up
- Checking network status
- Exporting network packet data
- Port forwarding
- Chapter 13 Storage management
- Chapter 14 Camera settings
- Chapter 15 Recorder management
- Chapter 16 User management
- Appendix A Specifications
- Appendix B PTZ protocols
- Appendix C Port forwarding information
- Appendix D KTD-405 keypad
- Appendix E Maximum pre-recording times
- Appendix F Supported PTZ commands
- Appendix G Default menu settings
- Index
Chapter 15: NVR management
TruVision NVR 21(S/P) User Manual 131
Restoring default settings
To restore all parameters to default factory settings:
1. From the menu toolbar, click System Settings > Configurations.
2. Click the Default tab.
3. Click the Default button. Enter the Admin password, click OK, and then click Yes to
confirm that you want to restore all parameters to default.
Or
Click the Restore tab. Enter the Admin password, click OK, and then click Yes to
confirm that you want to restore all parameters except network settings to default.
Note: Network information such as IP address, subnet mask, gateway, MTU, NIC
working mode, server port and default route are not restored to factory default
settings if Restore is selected.
Importing and exporting configuration settings
You can export and import configuration settings from a recorder. This is useful if you
want to copy the configuration settings to another recorder, or if you want to make a
back up of the settings.
Insert an external storage device in the recorder. Go to the System Settings >
Configurations > Import/Export Configuration File to import or export configuration
settings. Click Export to export the recorder’s configuration settings into an external
storage device or click Import to import configuration settings after selecting a
configuration file from the external storage device.
Viewing system information
You can check the current status of the recorder at any time by going to the System
Information menu. You can check the status of the device, cameras, recordings,
alarms, network, and HDDs.
To view system information:
1. From the menu toolbar, click System Settings > System Information.
2. To view device information, click the Device Info tab.
You can view the device name, model, serial number, firmware version, encoding
version, and panel version.
3. To view camera information, click the Camera tab.
You can view the status of each camera: camera number, camera name, status,
motion detection, tamper proof, video loss, preview link sum, and preview link
information.