User Manual

Chapter 10: Camera setup
TruVision NVR 22 (S/P) User Manual 57
Figure 21: IP camera window
Table 11: Description of the IP camera window
Option Description
1.
IP camera list
This shows the list of IP cameras added to the recorder. The camera
information shown is: Camera No., Status, PoE port, Edit, Advanced Set,
Live View, Camera Name, IP Camera Address, Manage Port, Protocol,
Device Model, Serial Number, and Firmware.
2.
Sync Password
Sets all connected TruVision IP cameras to the same admin password as
the recorder.
3.
Manual Add
Add a camera manually to the recorder by entering its IP address and other
required information.
4.
Device
Search/Add Search the network for available TruVision or other natively supported IP
cameras. Add an IP camera to the recorder system.
5.
Upgrade
Upgrade IP camera software. Insert USB flash drive in the recorder and
select the upgrade file. The camera will automatically reboot once the
software is upgraded.
6.
Delete
Delete the selected IP camera from the list.
7.
Refresh
Update the information displayed on a camera in the recorder device list.
To automatically add an IP camera:
1. From the menu toolbar, click Camera Setup > IP Camera Status.
2. Click Device Search/Add to search for any supported IP cameras located in the
recorder LAN.
Note: If cameras still have default settings, they might have the same IP addresses.
This creates an IP conflict. Before adding the IP camera to the recorder, use the
Edit button to assign a different IP address to each camera.
3. Check the boxes of the cameras that you want to add to the recorder.