User Manual

Chapter 10: Camera setup
64 TruVision NVR 22 (S/P) User Manual
Up-Down: Flip the image vertically.
Center: Flip both horizontally and vertically.
Note: This is only available for cameras that support the function.
6. Click Apply to save the settings and then click Exit to return to live view.
Motion detection
The motion detection menu allows you to enable or disable motion detection for each
camera as well as create motion grids, set the sensitivity of the motion detection, and
link motion detection to a specific action.
To set up motion detection:
1. From the menu toolbar, click Camera Setup > Motion Detection.
Areas covered by the red grid are sensitive to motion detection.
2. Select the camera to detect motion. Each camera must be set up individually.
3. Check Enable Motion Detection. If this is not enabled, motion will not be recorded.
4. Check Enable Dynamic Analysis. This allows you to see on-screen motion being
detected while setting up the feature. Areas where motion is detected are shown as
solid red squares in the motion grid.
5. Create the areas on-screen to be sensitive to motion.
Click and drag the mouse cursor across the window to select areas sensitive to
motion detection, which are shown as a red motion grid.
Click Full Screen to activate the whole screen or Clear to clear the screen.
6. Set the sensitivity level.
Drag the Sensitivity scroll bar to the desired sensitivity level. Maximum sensitivity is
6. Default is 4.