User Manual

Chapter 11: Network settings
TruVision NVR 22 (S/P) User Manual 75
2. Enter the required settings:
Option Description
1.
Working Mode
Select from Multi-address, Load Balance, and Net Fault Tolerance. This
option is not available on the TVN 22S.
Multi-address: Each LAN port is separate with its own IP address. This
allows one LAN port for the IP cameras and the other for client PCs such
as TruNav.
Load Balance: The bandwidth is divided over the two LAN ports with one
IP address.
Net Fault Tolerance: When one LAN port fails, the other one takes over.
This is the default option.
2.
NIC Type
Network interface card (NIC) is a device used to connect the recorder
to a
network. Select the NIC type used from the drop-down list.
3.
Internal NIC IPv4
Address
This is only available for TVN 22S. Enter the internal NIC IPv4 address.
This is the IP address of the recorder's internal network managing only
the PoE port cameras. This is not the LAN IP address.
Default value is 192.168.254.1.
4.
Bridge PoE
Camera Network
This is only available for TVN 22S. Check this box to enable the Bridge
PoE Camera Network.
Default value is Enable.
5.
Enable DHCP
DHCP (Dynamic Host Configuration Protocol) is a protocol for assigning
an IP address dynamically to a device each time it connects to a network.
Check this box if you have a DHCP server running and want your recorder
to automatically obtain an IP address and other network settings from that
server. The DHCP server is typically available in your router.
Default value is Disable.
6.
IPv4 Address
Enter the IP address for the recorder. This is the LAN IP address of the
recorder.
Default value is 192.168.1.82.