Quick Start Guide

ManualsBrandsInterlogix ManualsNetwork Video Recorders128 Channels TruVision Network Video Recorder, 576 Mbps, 3U, 64TB

P/N 1073375-EN • REV C • ISS 09NOV17

TruVision NVR 71 Quick Start

Guide

Figure

1: Back panel connections

1. SFP port (X4): Plug a small form-factor

transceiver into the port in order to connect fiber

cables.

2. eSATA: Connect an optional eSATA drive to

extend the internal storage or to archive.

3. RS-232 input: Text insertion for point-of-sale

and ATM devices. Also used by technical

support.

4. Alarm inputs (X16): Connect physical alarms

such as detectors, push buttons, etc.

5. Redundant power supplies (X2): Connect two

PSUs.

6. Audio input (X1): Connect a microphone for bi-

directional audio (not recorded).

7. Audio output (X1): Connect to speakers for

audio output.

8. USB 3.0 ports (X2): Connect a USB device,

CD/DVD burner or HDD.

9. Ethernet ports: Connect to network.

10. Reset pin hole: Hold down the reset button for

seven seconds to reset the network settings back

to factory default.

Note: This might cause the cameras to stop

recording and the software to be unable to

connect to the recorder.

11. Alarm outputs (X8): Connect physical alarm

outputs such as a siren, flash, or relay.

12. Ground: Connect to ground.

Summary of content (8 pages)

PAGE 1
TruVision NVR 71 Quick Start Guide Figure 1: Back panel connections 1. SFP port (X4): Plug a small form-factor transceiver into the port in order to connect fiber cables. 2. eSATA: Connect an optional eSATA drive to extend the internal storage or to archive. 3. RS-232 input: Text insertion for point-of-sale and ATM devices. Also used by technical support. 4. Alarm inputs (X16): Connect physical alarms such as detectors, push buttons, etc. 5. Redundant power supplies (X2): Connect two PSUs. 6.
PAGE 2
Figure 2: TVN 71 front panel 1 Status LEDs: Power: A steady GREEN light indicates that the recorder is operating correctly. A RED light indicates a fault. Event Alarm: A blinking RED light indicates that there is a sensor Alarm Input or another alarm such as motion or tampering. No light indicates no alarm. HDD: A blinking RED light indicates that the recorder is accessing the HDD in a read or write operation. A steady RED light indicates HDD failure. No light indicates that the unit is in idle state.
PAGE 3
2. Connect the power cords to the unit and turn on the power. 3. Set up the unit with the required settings using the setup wizard via the browser. First-time use The recorder has an express installation wizard that lets you easily configure basic recorder settings when first used. It configures all cameras simultaneously. The configuration can then be customized as required. By default, the setup wizard will start once the recorder has loaded.
PAGE 4
The default values for recorder network settings are: • DHCP: Disabled by default. • IP address - 192.168.1.82 • Subnet mask - 255.255.255.0 • Gateway address - 192.168.1.1 • Ports: When using the browser: RTSP port: 554 HTTP port: 80 When using TruNav: RTSP port: 554 Server/Client software port : 8000 Live view mode Live mode is the normal operating mode of the unit where you watch live pictures from the cameras.
PAGE 5
Legal and regulatory information Copyright © 2017 United Technologies Corporation. All rights reserved. Interlogix is part of UTC Climate, Controls & Security, a unit of United Technologies Corporation. All rights reserved Trademarks and patents Trade names used in this document may be trademarks or registered trademarks of the manufacturers or vendors of the respective products. Contact information and manuals For contact information go to: www.interlogix.com, or www.firesecurityproducts.
PAGE 6
equivalente, oppure rivolgervi e consegnarli presso i centri di raccolta preposti. Per maggiori informazioni vedere: ww.recyclethis.info. LT Elektros ir elektroninės įrangos šalinimas Įrangą, pažymėtą šiuo simboliu, draudžiama šalinti Europos Sąjungos viešose nerūšiuotų atliekų šalinimo sistemose. Eksploatavimui nebetinkamą įrangą pristatykite į tam skirtas surinkimo vietas arba, perkant naujus anlogiškus gaminius, grąžinkite ją pardavėjui, kad ji būtų tinkamai utilizuota.
PAGE 7
събиране. За допълнителна информация вижте: www.recyclethis.info. CS Nakládání s bateriemi Tento produkt obsahuje baterie, které nemohou být zneškodněny v Evropské unii jako netříděný komunální odpadu. Viz dokumentace k produktu pro informace pro konkrétní baterie. Baterie je označena tímto symbolem, který může zahrnovat i uvedena písmena, kadmium (Cd), olovo (Pb), nebo rtuť (Hg). Pro správnou recyklaci baterií vraťte svémudodavateli nebo na určeném sběrném místě. Pro více informací viz: www.recyclethis.
PAGE 8
savākšanas vietā. Sīkāku informāciju var iegūt vietnē: www.recyclethis.info. приема. Подробности можно найти на веб-сайте: www.recyclethis.info. NL Verwijderen van baterijen Dit product bevat een batterij welke niet kan verwijdert worden via de gemeentelijke huisvuilscheiding in de Europese Gemeenschap. Gelieve de product documentatie te controleren voor specifieke batterij informatie. De batterijen met deze label kunnen volgende indictaies bevatten cadium (Cd), lood (Pb) of kwik (Hg).