User Manual
Table Of Contents
- Important information
- Chapter 1 Product introduction
- Chapter 2 Physical installation
- Chapter 3 Getting started
- Chapter 4 Operating instructions
- Chapter 5 Live view
- Chapter 6 Playback functionality
- Chapter 7 Searching files
- Chapter 8 Archiving files
- Chapter 9 Web browser configuration
- Chapter 10 Camera setup
- Chapter 11 Network settings
- Chapter 12 Recording
- Chapter 13 Alarm and event setup
- Chapter 14 Device management
- Chapter 15 Storage management
- Chapter 16 User management
- Chapter 17 System information
- Appendix A Specifications
- Appendix B Port forwarding information
- Appendix C TruVision Mac Safari browser plug-in v3.0
- Appendix D Guidelines when using high camera count (>32 cameras)
- Appendix E Default menu settings
- Index
0BChapter 1: Product introduction
TruVision NVR 71 User Manual 7
Figure 1: Password activation window
User Name: It is always “admin”. It cannot be changed. The bar showing password strength
Enter the new admin password and confirm it.
Tips on creating a strong password:
A valid password range must be between 8 and 16 characters. You can use a combination
of numbers, lower and upper case letters, and special characters : _ - , . * & @ / $ ? Space.
The password must contain characters from at least two of these groups.
The password is case-sensitive so use a mixture of upper and lower case letters.
Do not use personal information or common words as a password.
Note: If you should forget your admin password, please contact Technical Support to reactivate
the unit with a new password.
Go to Chapter 16 “User management” on page 105 for further information on creating user
passwords.
Default network settings
The network settings are:
• IP address - 192.168.1.82
• Subnet mask - 255.255.255.0
• Gateway address - 192.168.1.1
• Ports:
When using the browser:
RTSP port: 554
HTTP port: 80
When using TruNav:
RTSP port: 554
Server/Client software port: 8000
Go to “Web browser” on page 45 for further information.