User Manual

12BChapter 13: Alarm and event setup
82 TruVision NVR 71 User Manual
a) Under the Arming Schedule tab click the timeline of the desired day of the week. The
Edit schedule window pops up. Enter the start and end times of the arming schedule.
Click Save.
You can define up to eight different periods during a day, and a different schedule for
each day of the week.
Note: The time periods defined cannot overlap.
b) To copy a day’s schedule to another day of the week click , which appears at the end
of the day’s timeline. The Copy to pop-up menu appears. Select the day or days of the
week to which to copy this day’s arming schedule and click OK.
5. If you want to copy the settings to other alarm outputs, select the desired alarm outputs
under “Copy to alarm”.
6. Click Save to save the changes.
Manual trigger
The manual trigger menu allows you to manually trigger outputs of the recorder.
To trigger or clear alarm outputs manually:
1. From the menu toolbar, click Configuration > Remote Configuration > Alarm & Event
Setup > Manual Trigger.
2. Select the desired alarm output and click the following buttons:
Trigger: Trigger an alarm output or stop an alarm output.
Trigger All: Trigger all alarm outputs or stop all alarm outputs.
Clear All: Stop all alarm outputs at once.
Note: The alarm output name can be entered in the Alarm Output menu.
Buzzer settings
When an alarm is triggered by the system or a camera, the recorder can be set up to respond
with a warning buzzer. The buzzer time is the time that it takes for the recorder to time-out the
buzzer when a continuous alarm occurs. For example, when a physical alarm input is
continuously triggered, the buzzer will time out after the time specified.
To set up alarm notifications:
1. From the menu toolbar, click Configuration > Remote Configuration > Alarm & Event
Setup > Buzzer Settings.
2. Under System buzzer timeout time select a buzzer time limit: 5 s, 10 s, 20 s, 30 s, 60 s,
120 s, 240 s, or Constant. Default is Constant.