User Manual

12BChapter 13: Alarm and event setup
TruVision NVR 71 User Manual 89
2. Select the Enable Intrusion Panel Connection check box to enable the intrusion panel
connection.
3. Set up the intrusion panel connection parameters.
a) Select which panel you want to set-up. Up to three panels can be set up.
b) Enter a name for the panel.
c) Enter the number of zones. Up to 32 panel zones can report to the recorder. The
number cannot be increased but you can allocate a different ID for each zone under the
“Intrusion Zone Setup” menu.
d) Enter the panel’s IP address. The IP address must be in the same LAN as the recorder.
e) Enter the port that is used to report the events. Default is 9999. This port number must
match the port number set up in the intrusion panel.
Caution: The recorder will reboot automatically when the intrusion panel port number is
changed.
4. Set up the heartbeat alarm parameters.
a) Select Enable Panel Heartbeat Alarm check box to enable the panel heartbeat alarm.
The heartbeat alarm will then be reported to the recorder.
b) Enter the interval between two heartbeats. It is measured in seconds. Default is 120 s.
This interval is valid even if the “Enable Panel Heartbeat Alarm” check box is disabled.
To be able to trigger a heartbeat alarm when the heartbeat is not received within this
interval, enable the “Enable Panel Heartbeat Alarm” check box.
The recorder heartbeat interval must always be higher than that of the intrusion panel.