User Manual
Table Of Contents
- Network access
- Checking your web browser security level
- Accessing the camera over the network
- Overview of the camera web browser
- Configuration menu overview
- Local configuration
- System time
- Network settings
- Recording parameters
- Video image
- OSD (On Screen Display)
- Overlay text
- Privacy masks
- Motion detection alarms
- Tamper-proof alarms
- Exception alarms
- Alarm inputs and outputs
- Cross line detection
- Intrusion Detection
- Camera management
- Camera operation
- Index
14 TruVision Panoramic Wi-Fi Wedge IP Camera Configuration Manual
To define the TCP/IP parameters:
1. In the Network panel, click the TCP/IP tab to open its window.
2. Configure the NIC settings, including the NIC Type, IPv4 settings, IPv6
settings, MTU settings, and Multicast Address.
3. If the DHCP server is available, check DHCP.
4. If the DNS server settings are required for some applications (e.g., sending
email), you should configure the Preferred DNS Server or Alternate DNS
Server.
5. Click Save to save changes.
To define the port parameters:
1. In the Network panel, click the Port tab to open its window.
2. Set the HTTP Port, RTSP port, HTTPS port, and Server port of the camera.
HTTP Port: The default port number is 80, and it can be changed to any port
number that is not occupied.
RTSP Port: The default port number is 554. It can be changed to any port
number in the range from 1 to 65535.
HTTPS Port: The default port number is 443. It can be changed to any port
number that is not occupied.
Server Port: The default server port number is 8000. It can be changed to
any port number in the range from 2000 to 65535.
3. Click Save to save changes.