User Manual
Table Of Contents
- Network access
- Checking your web browser security level
- Accessing the camera over the network
- Overview of the camera web browser
- Configuration menu overview
- Local configuration
- System time
- Network settings
- Recording parameters
- Video image
- OSD (On Screen Display)
- Overlay text
- Privacy masks
- Motion detection alarms
- Tamper-proof alarms
- Exception alarms
- Alarm inputs and outputs
- Cross line detection
- Intrusion Detection
- Camera management
- Camera operation
- Index
TruVision Panoramic Wi-Fi Wedge IP Camera Configuration Manual 39
Figure 11: Cross line detection menu
To define cross line detection:
1. In the Events panel, click the Cross Line tab to open its window.
2. Enable the Enable Cross Line Detection check box.
3. Click Draw Area. A crossing plane appears on the image.
4. Click on the line. You will see two red squares on each end. Drag one of the
red squares to define the arming area.
Select the direction as A<->B, A ->B, or B->A from the drop down menu.
A<->B: Only the arrow on the B side is shown. Only objects crossing the
configured line in both directions can be detected and alarms triggered.
A->B: Only objects crossing the configured line from the A side to the B side
can be detected and alarms triggered.
B->A: Only objects crossing the configured line from the B side to the A side
can be detected and alarms triggered.
5. Set the sensitivity level between 1 and 100.
6. Click Edit to set the arming schedule for the alarm input. See “Motion
detection alarms” on page 31 for more information to set up motion detection.
7. Configure the linkage action.
8. Click Save to save changes.