User Manual
Table Of Contents
- Network access
- Checking your web browser security level
- Accessing the camera over the network
- Overview of the camera web browser
- Configuration menu overview
- Local configuration
- System time
- Network settings
- Recording parameters
- Video image
- OSD (On Screen Display)
- Overlay text
- Privacy masks
- Motion detection alarms
- Tamper-proof alarms
- Exception alarms
- Alarm inputs and outputs
- Cross line detection
- Intrusion Detection
- Camera management
- Camera operation
- Index
40 TruVision Panoramic Wi-Fi Wedge IP Camera Configuration Manual
Intrusion Detection
Intrusion detection allows you to set up an area in the surveillance scene. If
someone enters the area a set of alarm action can be triggered.
Figure 12: Intrusion detection menu
To define intrusion detection:
1. In the Events panel, click the Intrusion Detection tab to open its window.
2. Enable the Enable Intrusion Detection check box.
3. Click Draw Area. Draw a rectangle on the image as a defense region. All
lines of the rectangle drawn must connect end-to-end to each other. Only one
area is supported. Click Clear to clear the area drawn.
4. Select the Region to be configured, and set the threshold, sensitivity and
percentage trigger area of the region.
Threshold: Range [0-10 s]. This is the time threshold that the object loiters in
the region. If you set the value as 0, an alarm is triggered immediately after
the object enters the region.
Sensitivity: Range [1-100]. This is the sensitivity value that defines the size
of the object that can trigger an alarm. When the sensitivity is high, a very
small object can trigger the alarm.