User Manual
Table Of Contents
- Network access
- Checking your web browser security level
- Accessing the camera over the network
- Overview of the camera web browser
- Configuration menu overview
- Local configuration
- System time
- Network settings
- Recording parameters
- Video image
- OSD (On Screen Display)
- Overlay text
- Privacy masks
- Motion detection alarms
- Tamper-proof alarms
- Exception alarms
- Alarm inputs and outputs
- Cross line detection
- Intrusion Detection
- Camera management
- Camera operation
- Index
TruVision Panoramic Wi-Fi Wedge IP Camera Configuration Manual 45
If Overwrite is enabled, the oldest files are overwritten when the storage
becomes full.
To format the storage devices:
1. In the Storage panel, click the Storage Management tab to open its window.
2. Enable the HDD Number column to select the storage.
3. Define the quota percentage for snapshots and recordings by modifying the
values for each in Percentage of Snapshot and Percentage of Record.
4. Click Format. A window appears to confirm your formatting permission.
5. Click OK to start formatting.
Recording schedule
You can define a recording schedule for the camera in the “Record Schedule”
window. The recording is saved on to the SD card or NAS in the camera. The
camera’s SD card provides a backup in case of network failure.
The selected recording schedule applies to all alarm types.
Pre-record time
The pre-record time is set to start recording before the event. For example, if an
alarm triggers recording at 10:00, and the pre-record time is set as 5 seconds,
the camera starts to record the event at 9:59:55. The pre-record time can be
configured as No Pre-record, 5 s, 10 s, 15 s, 20 s, 25 s, 30 s, or not limited.
Post- record time
The post-record time is set to stop recording after the event. For example, if an
alarm triggered recording ends at 11:00, and the post-record time is set as 5
seconds, the camera records until 11:00:05. The post-record time can be
configured as 5 s, 10 s, 30 s, 1 min, 2 min, 5 min, or 10 min.