User Manual Instruction Manual

Chapter 4: Camera setup
UltraView IP PTZ 36X Camera User Manual 31
Figure 13: Video tampering screen
To define the on-screen area that can trigger a tamper alarm:
1. In the Channel Parameters folder, click the Video Tampering subfolder to
open its screen.
2. Click the Zone Settings tab.
3. Check the Enable Video Tampering box. The three Settings buttons are
activated.
4. Define the area for camera tampering.
Check the Start Draw box. Place your mouse pointer at a point on the screen
from where you want to start marking the video tampering area. Drag the
mouse pointer over the screen to mark the area sensitive to tampering. Only
one area can be drawn.
Click Clear All to delete the area.
5. Select the tampering sensitivity level: Low, medium or high.
6. Define the alarm response method to a tamper alarm.
Select the Linkage tab to select how you want to be notified when tamper is
detected. Check one or more of the response methods: