Manual

CyberDome II
Installation Manual
50
CyberDome II protocol functionality
All Protocols support the following basic commands:
• Pan and tilt
• Zoom—wide and telephoto
• Iris—open and close
• Focus—near and far
• Addressing cameras
Note: Shaded cells in the tables below are unconventional by that protocol’s standards.
Table 10. Pelco D and P commands supported
Command Note
Set preset out of GUI See Pelco keypad documentation
Go to preset XX See Pelco keypad documentation
Flip (rotate 180 degrees) Preset 33
Run pattern (learn number 1) See Pelco keypad documentation
Set left limit stop Preset 92
Set right limit stop Preset 93
Enter into menu mode Preset 95
Begin frame-scan (Preset tour number 1) Preset 98
Begin autoscan (Pan) Preset 99
Table 11. Ultrak commands supported
Command Note
Set preset out of GUI See Ultrak keypad documentation
Go to preset XX See Ultrak keypad documentation
Run learn tour 1 Preset 80
Run learn tour 2 Preset 81
Run learn tour 3 Preset 82
Program learn tour 1 Preset 83
Program learn tour 2 Preset 84
Program learn tour 3 Preset 85
Run preset tour 1 Preset 87
Run preset tour 2 Preset 88
Run preset tour 3 Preset 89
Enter into menu Preset 90
Day/night toggle Preset 94