Spec Sheet

V T/ VR1500
Series
IFS Video with One-Way Data
IFS
®
Line / Fiber Transmission
interlogix.com
OVERVIEW
The IFS VT/VR1500 Series video and data transceiver supports
the simultaneous transmission of video and one-way return data
over one or two multimode optical fibers. The module is universally
compatible with major CCTV camera manufacturers and supports
RS-232 and RS-422 data interfaces and all major data protocols.
Plug-and-play design ensures ease of installation requiring no
electrical or optical adjustments. The modules incorporate power,
video presence, optional contact closure, data out, and AGC
status indicating LED’s to monitor proper system operation. The
VR1500WDM-CC features an optional contact closure input that
allows an additional device such as a dome tamper switch or alarm
input to be added and its signal transmitted back to the monitoring
location. This feature eliminates the need for installing additional
wiring to support the alarm contact closure. The modules are
available in either stand-alone or rack mount versions.
APPLICATION EXAMPLES
• CCTV with One-Way PTZ Camera Control
• CCTV with Remote Signalization
SYSTEM DESIGN
STANDARD FEATURES
• AM Video Transmission
• NTSC, PAL, SECAM Compatible
• Full Color Compatibility
• Supports RS-232 or RS-422 Data Interfaces
•
T
ransparent to Data Encoding/Compatible with Major CCTV
Camera Manufacturers
• Full Range Automatic Gain Control (AGC)
• No In-field Electrical or Optical Adjustments Required
• Power, Video Presence, Data Out, and AGC Status Indicating
LED’s to Monitor System Performance
• Integrated WDM for Greater Product Reliability
• Distances up to 2.5 miles (4 km) without Repeaters
• NTCIP Compatible
• Tested and Certified by an Independent Testing Laboratory for
Full Compliance with the Environmental Requirements (Ambient
Operating Temperature, Mechanical Shock, Vibration, Humidity
with Condensation, High-Line/Low-Line Voltage Conditions and
Transient Voltage Protection) of NEMA TS-1/TS-2 and the
Caltrans Specification for Traffic Signal Control Equipment.
• Hot-Swappable Rack Modules
• Automatic Resettable Fuses on all Power Lines
• Comprehensive Lifetime Warranty
VR1500
Video
(Coax)
Control
Data
Video
(Coax)
2 Fibers
62.5/125µm MM
VT1500
Control
Data
up to 2.5 miles
(4 km)
ifs
International
Fiber
Systems
Incorporated
203.426.1180
ifs
International
Fiber
Systems
Incorporated
203.426.1180
Video
Video Input: 1 volt pk-pk (75 ohms)
Bandwidth: 5 Hz - 10 MHz
Differential Gain: <5%
Differential Phase: <5°
Tilt: <1%
Signal-to-Noise Ratio (SNR): >55 dB @ 10 dB ATTN.
Data
Data Interface: RS-232, RS-422
Data Format: NRZ, NRZI, Manchester, Bi-phase
Data Rate: DC-100 Kbps (NRZ)
Loss of relay
Loss of Video:
Relay (Optional): SPST Relay
100 v, 0.5 A Contact Rating (Normally Open)
Wavelength 850/1310 nm, Multimode
Number of fibers VTVR1500: 2, VTVR1500WDM: 1
Connectors
Optical: ST
Power and Data: Terminal Block with Screw Clamps
Video and Sync: BNC (Gold Plated Center-Pin)
Electrical & Mechanical
Power:
VT: 24 VAC C.T., 11-14 VDC @ 200 mA
VR: 12 VDC @ 200 mA
Rack: From Rack
Number of Rack Slots: 1
Current Protection: Automatic Resettable Solid-State Current Limiters
Max. RG59 Cable Length: 750 ft.
Circuit Board: Meets IPC Standard
Size (in./cm.) (LxWxH)
Surface Mount: 7.0 x 4.9 x 1.0 in., 17.8 x 12.5 x 2.5 cm
Rack Mount: 7.7 x 5.0 x 1.0 in., 19.6 x 12.7 x 2.5 cm
Shipping Weight: < 2 lbs./0.9 kg
Environmenta
MTBF: > 100,000 hours
Operating Temp: -40° C to +74° C
Storage Temp: -40° C to +85° C
Relative Humidity: 0% to 95% (non-condensing)†
†May be extended to condensation conditions by adding suffix ‘–C’ to
model number for conformal coating.
Part Number
Optical Pwr. Budget
Max. Distance*
Multimode
62.5/125µm**
2.5 miles (4 km)
2.5 miles (4 km)
PS-12VDC 12 Volt DC Plug-in Power Supply (Included)
PS-12VDC-230 12 Volt DC Plug-in Power Supply, 230 VAC Input (Included if specified at time of order)
Add ‘-R3’ to Model Number for R3 Rack Mount - No Charge (Requires R3 Rack purchased separately)
Add ‘-C’ for Conformally Coated Printed Circuit Boards (Extra charge, consult factory)
Add ‘-CC’ for Contact Closure on Receiver Only
VT1500
VR1500
VT1500WDM
VR1500WDM
2
1
Fibers Required
14 dB
24 dB
Video Transmitter/Data Receiver (850 nm)
Video Receiver/Data Transmitter (850 nm)
Video Transmitter/Data Receiver (850/1310 nm)
Video Receiver/Data Transmitter (1310/850 nm)
Accessories
◆
Options
Description
Ordering Information
Made in the USA
Complies with FDA Performance
Standard for Laser Products, Title 21,
Code of Federal Regulations, Subchapter J
Specifications
Agency compliance
GE
Security
System Design
North America
T 888-GE-SECURITY
888-437-3287
F 503-691-7566
E [e-mail]
Asia
T 852-2907-8108
F 852-2142-5063
Australia and New Zealand
T 613-9239-1200
F 613-9239-1299
Europe
T 44-113-238-1668
F 44-113-253-8121
Latin America
T 305-593-4301
F 305-593-4300
gesecurity.com/ifs
Specifications subject to
change without notice
© 2008 General Electric Company
All Rights Reserved
* Optical transmission distance is limited to optical loss of the fiber and any additional loss introduced by connectors, splices and patch panels.
Distance can also be limited by fiber bandwidth. ** For 50/125 Fiber, subtract 4 dB from Optical Power Budget.
◆
All accessories are third party manufactured.