User's Manual Part 1

18 I-Wave Installation Guide

Wiring Underwater Lights

CAUTION: A Ground Fault Circuit Interrupter (GFCI) must be provided for high

voltage pool/spa lights. Do not use a GFCI circuit breaker.

High-Voltage Underwater Lights

The I-Wave Control Center comes equipped with two décor knockouts on the dead front and

one side knockout for installation of GFCI receptacles. (See Figure 3-7).

NOTE: If using the décor knockouts to install a GFCI, you must use the standoffs provided with

the Control Center to mount your GFCI.

Install a GFCI receptacle and connect the neutral and hot wire, from the circuit breaker, to the

LINE side of the GFCI. (See Figure 3-8).

Connect the neutral (white wire) to the GFCI.

Connect the hot (black wire) as follows:

To the LOAD side of clock,

Then out the LINE side of the clock to the LOAD side of the GFCI. (See Figure 3-8.)

Connect the ground (green wire) from the light to the grounding bar inside the Control Center.

(0000000)(0000000)

Figure 3-7 Figure 3-8 Figure 3-7 Figure 3-8