Instructions / Assembly

This WI is Applicable to the EJ500C In-Wall Digital Timer

Denotes important check/inspection step

Denotes any potential injury or damage to

the equipment

Use the end of a non-metallic object,

such as a pen, to pry the battery

holder open.

Insert the other battery, plus side

down, on top of the installed battery.

With the prongs facing outward and

the holes on the side of the holder

facing you, insert a new battery (plus

side down), into the battery holder

(plus side on bottom).

From inside the battery holder,

slightly bend the battery contacts

outward with a toothpick or small

paperclip to increase tension on the

new batteries.

WI-000004

EJ500C

Open the timer door.

1 of 2

Work

Instruction

Revision

If you are replacing the batteries, pry

loose the batteries with an end of a

paperclip.

Battery

Installation/Replacement

Page

5 6

Apply

grease.

PAGE 1
Work Instruction EJ500C This WI is Applicable to the EJ500C In-Wall Digital Timer 2 1 Battery Installation/Replacement 1 2 3 4 5 6 Open the timer door. Use the end of a non-metallic object, such as a pen, to pry the battery holder open. 3 4 If you are replacing the batteries, pry loose the batteries with an end of a paperclip. From inside the battery holder, slightly bend the battery contacts outward with a toothpick or small paperclip to increase tension on the new batteries.
PAGE 2
Work Instruction 7 EJ500C Battery Installation/Replacement 1 7 Insert the holder into the timer with the plus and minus indicators facing the left side of the timer.