Owner's Manual

• Enable the circuit whose holiday schedule you wish to review
• Pressprogram(PROG).
• PressHLDY.
• Entertheholidayreferencenumber.Example2.
• PressREVrepeatedly to display the scheduled holiday switching times.
To delete or make revisions during review, press CLEAR when the data
appears in the display, enter the new data if required, then press OK.
• IfyouclearspecialholidayoperationyoumustfirstmovetheRUN/SET
selector to RUNtemporarily before you can clear the holiday.
Return to SETthen press SETUP,HLDY,REV,until the holiday
reference number appears, then press CLEAR.
To delete or make revisions during review, simply press CLEAR when the
data appears in the display, enter the new data if required, then press OK.
To Review Program Times
BesureRUN/SET switch is in SET position.
• Pressprogram(PROG).
• Enable one circuit at a time to complete the review.
• Selectthedayorgroupentered.Notethatifyouenterdataasaday
group, then attempt to review an individual day, the display will tell you
itis“endofreview”.Inotherwords,nodatainexistence.Thisisbecause
you must review data just as entered.
REVIEW, REVISE OR DELETE INFORMATION, cont’d
To Review Program Times, cont’d
Example: Enable circuit 1, then Press WKDY. Press REV repeatedly to
reviewallprogramdataforMondaythroughFriday.Followingthis
6
6
Enable
Disable
ON/OFF
PROG
HLDY
MON
2
REV
REV REV
...
PROG
RUN
SET
Enable
Disable
ON/OFF