Owner's Manual

3
4
• PressOK.
• EntertheswitchONtime.Example:8:00AM–press8,0,0,AM.
• PressOK.
• EnterthetimetheloadshouldswitchOFF.
 Example:5:00PM–press5,0,0,PM.
• PressOK.
Repeat these steps for all ON/OFF times required. If you want to
enter multiple switch OFF times, simply press OK when the display is
prompting for a switch ON time. This is convenient for ensuring that
loads are off at the end of the day if they have been overridden after
normal hours.
Repeat these steps for all available circuits. Besure to disable all circuits
not being programmed and enable only the circuit(s) you are currently
programming. To save all programming, place RUN/SET in RUN
position.BesureallEnable/Disable switches are in the Enable position for
the circuit(s) to operate automatically.
SPECIAL LOAD PROGRAMMING
Astro Load Operation
(For sunset to sunrise lighting control)
You must set up the astro zone and sunset and sunrise times for ASTRO
to function. If you have not done so, press SETUP, then ASTROand refer
to setting the Astro function in Section 2.
•PressProgram(PROG).
• Enable the circuit controlling the load you wish to switch on at sunset
and off at sunrise times. Disable all others.
• Enterthedayorgroupofdaysonwhichtheloadshouldswitch.
Example: all days, press 0/ALL.
• PressOK.
SPECIAL LOAD PROGRAMMING, cont’d
Astro Load Operation, cont’d
3
4
PM
THU
5
ALL
0
ALL
0
AM
WKDY
8
ALL
0
ALL
0
OK
OK
OK
PROG
SET UP
ALL
0
ASTRO
Enable
Disable
ON/OFF
OK