Owner's Manual

• AttheswitchONprompt,pressASTRO.

• PressOK. The display prompts Sndn (for switch on at sundown).

• AttheswitchOFFprompt,pressASTRO.

• PressOK. The display prompts SnuP (for switch off at sun up).

If desired, you can program the load to switch OFF at a fixed time rather

than at sunrise by simply entering a time of day, rather than ASTRO when

promptedforthe“SwitchOFF”time.YoucanalsoprogramafixedON

with an ASTRO OFF for early morning lighting.

You can also program ASTRO times to switch on at sunrise and off at

sunset for reverse action ASTRO control such a lighting in tunnels.

Follow the program steps listed previously except the last four steps.

•AttheswitchONprompt,pressASTRO.

• PressAM (this causes the lights to switch on at sunrise).

• PressOK.

• AttheswitchOFFprompt,pressASTRO.

• PressPM (this causes the lights to switch off at sunset).

• PressOK.

If you want loads to switch ON for a short pulse (for bell ringing or

latching contactors) use pulse operation.

Pulse Operation (1to127seconds)

• Pressprogram(PROG).

• Enable the circuit for the load for which you want to have a pulse

operation. Disable all others.

• Enterthedayorgroupofdayswhichtheloadshouldhaveapulse.

Example:MondaythroughFriday–pressthe8/WKDY key.

SPECIAL LOAD PROGRAMMING, cont’d

Pulse Operation, cont’d

ASTRO

PROG

Enable

Disable

ON/OFF

WKDY

ASTRO