Owner's Manual

• PressOK.
• EnterthepulseONstarttime.
 Example:8:00AM–press8,0,0,AM. Do Not press OK.
• PressPULSE Do Not press OK.
• Enterthelengthofthepulseorinterval.
 Example:pulseof8seconds,press8.
• PressOK.BesuretopressPROG before starting the next program for
other circuits.
You can also program an OFFPulse which is a convenient way to
momentarily flash lights off as a pre-warning signal.
•PressPROG.
• Enable the circuit which you wish to have an off pulse.
• Enterthedayorgroupofdayswhichtheloadshouldhaveanoffpulse.
Example:MondaythroughFriday–pressthe8/WKDY key.
• PressOK; Press OK again to skip the switch on time and advance to
“switchoff”time.
• Enterthepulsestarttime.Example:4:50PM–press4,5,0,PM.
Do Not press OK.
• PressPULSE.
• Enterthelengthofpulse.Example:apulseof2seconds,press2.
• PressOK.Theload(lights)willflashofffor2secondsat4:50PM.
If you want to switch a load ON for an extended period of time (min.,
hours or days) use interval operation.
Interval Operation (1min.to6days,23hoursand59min.)
• Pressprogram(PROG).
• Enable the circuit for the load for which you want to have an interval
operation. Disable all others.
SPECIAL LOAD PROGRAMMING, cont’d
Interval Operation, cont’d
4
4
OK
WKDY
8
PULSE
PROG
5 0
OK
WKDY
8
4
OK
OK
PROG
2
PM
PULSE
Enable
Disable
ON/OFF
ALL
0
ALL
0
OK
WKDY
8
AM
Enable
Disable
ON/OFF
PROG