Owner's Manual

KEYBOARD/DISPLAY CHECK LIST
• Time switch is installed and wired in accordance with NEC and local
requirements by a qualified electrician.
• Display/keyboardmoduleissecurelyconnectedtothemulti-pin
connector from the relay board (see illustration).
• Turnonpoweratthebreakerpanel.
• Verifythatoneormoredisplaysegmentsarelit.
• If programming for the first time, clear the memory as follows:
Press CLEARkey (and hold). While holding the CLEAR key, press and
release the recessed RESET button. Release the CLEAR key only after
“rESEt” appears in the display.
• PressON/OFFkey for available circuit(s) to verify proper load wiring
and operation. If wired in the conventional manner, (loads connected to
the normally open contacts), the green LED will be on when the load is
on. The load(s) may be left on or off during programming.
• Beforebeginningtoprogram,makealistofyourprogramrequirements
or use the convenient program chart on the previous page.
SET-UP
Setting the Time
Place RUN/SET switch in SET position and follow the red blinking LED
prompts.
• Enterdayoftheweek(SundaythroughSaturday).
Example: Wednesday – press WED/4.
• PressOK.
• Enterthecurrenttime.Example:2:45PM–press2,4,5,PM.
• PressOK.
IfyouforgettoselectAMorPMyouwillreceivean“ERR1A”message.
Simply press CLEAR,enterAMorPM,andpressOK.
SET-UP, cont’d
1
2
CLEAR
Enable
Disable
ON/OFF
RESET
MON
2
PM
WED
4
THU
5
WED
4
RUN
SET
OK
OK
Straight in
Display/Keyboard
Module
1
2