Owner's Manual

2
Setting the Date
• Entercurrentdatebymonth,dayandtwodigitsfortheyear
 (00=2000).Example:June2,1999=6,0,2,9,9–theleadingzerois
not necessary – press 6,0,2,9,9.
• PressOK.
Ifyoureceivean“ERR19”messageyouhaveaconflictwiththeday
or date. Press CLEARand check the date. Use the CLEAR key to delete
the wrong date then re-enter and OKthe correct date. If the date is
correct press SETUPthenCLEARand re-enter, then OK the day and
time of day. You will need to re-enter, then OKthe month, day and year.
Setting the Astro Function
(required for sunset to sunrise load control)
If not required, press holiday (HLDY) and proceed to Creating a Holiday
or (PROG) and proceed to Programming Load Operation for Fixed Times
to begin programming switching times.
• Enterthezoneyouarein(seeAstromaponthenextpage).
Example: Chicago zone 5 – press 5.
• PressOK. Time displayed is the actual sunrise time for current day
at the center of the time zone. Reference the Astro map for suggested
offsets of selected cities not in the center of the time zone. Press CLEAR
one or more times to delete one digit at a time, then enter the desired
time.Example:ForChicago,torevise5:40AMtobe5:20AM–press
CLEAR,CLEAR,2,0.
• PressOK. The time displayed is the actual sunset time for the current
day at the center of the time zone. Revise using same offset procedure as
sunrise, if necessary. Sunset is usually offset by the same amount of time
as sunrise, although they can be different and can be offset by several
hours for special applications.
• PressOK.
SET-UP, cont’d
Creating a Holiday
2
MON
2
FRI
6
WKND
9
WKND
9
ALL
0
OK
CLEAR
CLEAR
MON
2
ALL
0
THU
5
OK
OK
OK