User's Manual

Four: Programming the PE953 Hand-Held Controller 43
Providing a brighter solution.™
If the action is successful, the screen displays the word SUCCESSFUL, as shown, then returns
to the LEARN MODE screen.
Any existing network or configuration programming in the PE653 Receiving Device is now
deleted. The entire system is now at factory reset state and the components are ready to be linked
together within a new electronic network.
Linking the Hand-Held Controller to the PE653 Receiving Device
This procedure creates a network connection between the Hand-Held Controller and the PE653
Receiving Device by including the PE653 into the PE953 controller., making it possible to
complete the rest of the setup procedure and operate the system.
NOTE: If the word FAILURE appears at the bottom of the screen during any of the following
steps instead of SUCCESSFUL, repeat the programming procedure, or try replacing the
batteries in the Hand-Held Controller. If the problem persists, contact Intermatic Customer
Service.
If necessary, press and release any button on the Hand-Held 1.
Controller to wake it from sleep. When all programming is deleted,
the Hand-Held automatically displays the LEARN MODE screen,
as shown. If the screen is not displaying LEARN MODE, press and
hold the <P/S> and <ENTER> buttons at the same time to put the
device into programming mode. You are in programming mode
when the LEARN MODE screen is displayed, as shown at the right.
Press and release the2. <3> function button to select INCLUDE
DEVICE. The screen refreshes with instructions to PRESS BUTTON
ON DEVICE TO INCLUDE, as shown.
Using a pen or pencil, press the 3. INCLUDE
button — to the right of the red light — as
shown.
If the action is successful, the screen displays
the word SUCCESSFUL, as shown, then
returns to the programming screen (LEARN MODE).
NOTE: If the PE653 has not successfully been included and you are seeing only the word
FAILURE at the bottom of the screen, repeat the two procedures Deleting Any Existing
Programming and Linking the Hand-Held Controller to the PE653 Receiving Device. If the
problem persists, contact Intermatic Customer Service.