User's Manual

44 Multi-Wave PE653-PE953 Installation Guide

Conﬁguring for a 1-Speed or 2-Speed Pump

The default setup is for a single-speed pump, which you turn ON and OFF using button 1 on the

Hand-Held Controller.

If the pool/spa installation uses a two-speed pump, you need to program the Hand-Held

Controller to be able to switch between speeds. Once conﬁgured, the Hand-Held Controller

controls these pumps as follows:

Button • <1> selects High speed.

Button • <2> selects Low speed.

If necessary, press and release any button on the Hand-Held 1.

Controller to wake it from sleep. If the screen is not displaying

LEARN MODE, press and hold the <P/S> and <ENTER> buttons at

the same time to put the device into programming mode. You are in

programming mode when the LEARN MODE screen is displayed, as

shown at the right.

Press the 2. DOWN arrow button until you see the PE653 OPTION

screen, as shown.

Press and release the3. <1> function button to select PUMP. The

screen refreshes, as shown.

Press the 4. UP or DOWN arrow button to change from 1SPD to

2SPD, then press the <ENTER> button. The screen adds the word

SUCCESSFUL, then returns to the programming screen.

Press the 5. <ENTER> button again to return to the Main screen.

Calibrating Pool, Spa and Air Temperature Settings

If there is a discrepancy between temperatures shown on the Hand-Held Control and

independent thermometers used to measure temperatures of pool, the spa and the air, you can

calibrate the Hand-Held’s settings to match the independent thermometers.