User's Manual

Five: Everyday Use of the PE953 Hand-Held Controller 53
Providing a brighter solution.™
Controlling the PE653 Receiving Device
To control settings configured with the PE653 Receiving Device
Press and release any button on the Hand-Held Controller to wake 1.
it from sleep. (The unit goes to sleep to conserve battery life when it
has been idle for 60 seconds.)
Press the 2. <ENTER> button until you see the PE653 screen, as
shown.
Operating Programmed Functions
Depending on how you have wired the system, the five function buttons on the Hand-Held
Controller operates the five circuits in the PE653 Receiving Device.
When you press any of these buttons, the appropriate circuit toggles ON or OFF. In addition,
when the circuit is ON, the Hand-Held Controller’s display shows the circuit number along the
top of the screen.
Changing between Pool and Spa
The Valve Actuator (PE24VA) that you have installed in the system directs water either to the pool
or the spa. To use the Hand-Held Controller to control this valve:
Press and release any button on the Hand-Held Controller to wake 1.
it from sleep. The screen display should look generally like the
example on the right.
If not, press the <ENTER> button until you see this screen.
NOTE: The lower-right area of Hand-Held Controller Screen displays
the current mode for the system — in this example it is POOL. The screen will indicate:
POOL if the valve actuator is in pool mode
SPA if in spa mode
The number following the word POOL or SPA is the current water temperature for the water
in whichever mode is being displayed.
Press and release the 3. <P/S> button. The system toggles between POOL and SPA mode.
:
In the example at the right, the mode is now changed to SPA, and 4.
the temperature shown is the water temperature of the SPA.
NOTE: The large numeric display shown on the Hand-Held
Controller Screen shows the current time of day.