User's Manual

56 Multi-Wave PE653-PE953 Installation Guide
Copyright © 2010 Intermatic, Inc.
Controlling PE650 Functions
Depending on how the site has been installed with the PE650 Receiving Device, there may be
up to five circuits being controlled. The five function buttons on the PE653 Hand-Held Controller
will control the five circuits in the PE650 Receiving Device.
If necessary, press and release any button on the Hand-Held Controller to wake it from sleep. 1.
If the PE650 screen (shown at the right) is not displayed, press the 2.
<ENTER> button until you see the PE650 screen, as shown.
Press the function button for the circuit you want to turn ON or 3.
OFF.
Buttons• <1>, <2>, and <3> control circuits 1, 2, and 3 on the Three-Circuit Clock
Mechanism (P1353ME) that is installed on the left side of the Receiving Device.
Buttons • <4> and <5> control Relay 1 and Relay 2 on the Valve/Pump Switch Control
(P4243ME) that is installed on the right side of the Receiving Device.
The Hand-Held Controller’s display shows the circuit number along the top of the screen.
Changing Batteries in the Hand-Held Controller
The Hand-Held Controller requires three (3) AA batteries. Battery life is approximately one year
in typical use. When the batteries are weak, the screen displays a
LOW BATT message shown.
To change the batteries:
Use a small Phillips screwdriver to 1.
remove the three screws on the back of
the unit, as indicated.
Place three new batteries in the unit, making sure to observe “+” 2.
and “–” polarity.
Be sure to re-install the gasket correctly to maintain the water-3.
tight seal.