User Manual

Five: Using the PE953 with the PE650 Receiving Device 37
Providing a brighter solution.™
Section 5:
Using the PE953 with the PE650
Receiving Device
It’spossibletocontrolaPE650networkwiththenewer,moreadvanced
PE953 Hand-Held Controller Control.
Linking the PE953 Hand-Held Controller with the PE650
Receiving Device
This procedure creates a network between the Hand-Held Controller and the
PE650 Receiving Device, making it possible to complete the rest of the setup
procedure and operate the system.
NOTE: If the word FAILURE instead of SUCCESSFUL appears at the bottom
of the screen during any of the following steps, repeat the programming
procedure, then try replacing the batteries in the Hand-Held. If the
problem persists, contact Intermatic Customer Service.
1. Ifnecessary,pressandreleaseanybuttononthe
Hand-Held Controller to wake it from sleep. If the
screen is not displaying LEARN MODE, press and
hold the <P/S> and <ENTER> buttons at the same
time to put the device into programming mode. You
are in programming mode when the LEARN MODE
screen is displayed, as shown at the right.
2. Press and release the <3> function button to select
INCLUDE DEVICE. The screen refreshes with
instructionstoPRESSBUTTONONDEVICETO
INCLUDE,asshown.
3. Press the black button on the base of the antenna of the PE650.
Iftheactionissuccessful,thescreendisplaysthewordSUCCESSFUL,as
shown, then returns to the LEARN MODE screen.
NOTE: If the two devices are not successfully linked
and you are seeing the word FAILURE at the bottom
of the screen, carefully repeat the procedure. If
the problem persists, contact Intermatic Customer
Service.
4. Press the <ENTER> button if you wish to return to the Main screen.
ThecircuitswiredinthePE650network(uptove)cannowbecontrolled
ON/OFFwiththevefunctionbuttonsonthePE953Hand-HeldController.